I get a lot of questions from people about removing their aluminum siding and potentially getting back to the original wood underneath. Is it possible? Is it feasible? What will I find? After all, siding is one of the 5 Worst Mistake of Historic Homeowners. Let me start by saying that removing aluminum siding is not complicated. It can be tedious work but there is nothing particularly complex about the process which makes it a perfect DIY project. Most times aluminum siding was installed right over the old wood with very few modifications. It was cheaper to do that way because removing the wood siding was usually cost prohibitive. That’s good news because if your old house originally had wood siding then it is probably still hiding underneath all that tin foil. The one caveat to removing aluminum siding, and vinyl siding for the matter, is that you don’t know what the condition of the wood underneath is. If you are willing to roll the dice a little and have enough money in the budget to cover some repairs to the original siding then removing your aluminum siding is definitely a worthwhile option. But before you start you need to embrace the idea that you WILL have repairs needed to your home’s envelope when you remove aluminum siding. There are two schools of thought on removing aluminum siding.
If you just want to get this stuff off and send it to the scrap yard then the work is much easier. You can damage and tear the stuff apart pretty easily and have your house unwrapped in no time. If you want to remove a section of the siding and then reinstall it that requires much more finesse. We’ll talk about both below. How to Remove Aluminum SidingStep 1 Play DetectiveBefore you break out your pry bar peel back a corner of the siding in a couple places and see what is going on under there. Knowing what’s underneath first will help you plan your work going forward. Is it clapboard, shingles, asbestos siding? You need to know what you are getting into. Step 2 Peel it BackAluminum siding is very sharp and can easily cut you so before you do anything put on a pair of work gloves. Aluminum siding and vinyl siding are attached much the same way. They are nailed across the top of each piece and the bottom of the lap hooks into the top of the following piece. Removal For RepairUsing a metal clothes hanger or other small hook dig into the end of one of the pieces of siding which will allow you to pull it off. Pull the bottom down and away and then you should be able to simply unzip that piece horizontally across the wall all the way down to the end. That will give you access to the nails holding the piece below the one you just unzipped so you can pry them out with a pry bar to free the piece from the wall. Removal For RestorationIf you are getting rid of your aluminum siding then just grab that pry bar and starting at a corner tear into this stuff. You can really just rip it off pretty easily. There may be some nails that need a pry bar’s help to come loose, but with some muscle it will come free. Step 3 Nailing Channels & TrimOn outside and inside corners you may have little channels that the aluminum slots into. These can be pried off by finding the nails that hold them in place too. Also depending on your siding salesman your exterior trim and fascia may have been wrapped in aluminum which creates just one more thing to remove. This cannot be removed without damaging the aluminum which is fine if you plan to trash it but can be a problem if you are planning to keep your aluminum. Generally the aluminum that wraps over your old wood trim is held in place with small aluminum nails. They are a bit of a pain to pry out, but if you can get a corner started it is usually easily to peel the aluminum back and let the nails come with it rather than trying to pry each nail out. Step 4 Aluminum SoffitsThe open eaves in old houses are another thing that often get covered up and turned into what appear to be vented aluminum soffits. These soffits are very easy to remove. Each panel is attached with a couple small nails to the sides of the J-channel. I honestly just get the first one off and using the claw side of my hammer just yank the rest of it down before undoing the nails holding the J-channel in place. Step 5 InsulationOften you’ll find 1/2″ styrofoam or other rigid insulation underneath the aluminum siding which was nailed into the siding with fat headed roofing nails. Removing this stuff is simple since it is so fragile and can be torn away from the building simply. Removing the myriad of nails throughout the old siding is the time consuming process. Removing the nails and patching all the holes is what takes me the most time in the whole process probably. What to Expect After Removing Aluminum SidingOnce you’ve got everything off you can finally see what your house was supposed to look like. In my experience there are a few things that often require restoration after we unwrap an old house.
If you can be prepared for some of these possibilities then you’ll be well ahead of the game. Removing aluminum siding can really do wonders to your home’s curb appeal if you have the budget to restore the siding underneath. We’ve unwrapped a lot of houses and it never stops being fun for me to see what we find underneath. The depth and beauty of these old houses can really shine again once you get that awful fake stuff off its face. And one last tip: don’t forget to haul all this aluminum to the recycling center for a nice payday at the end. Getting a check for a couple hundred bucks at the end of a hard day’s work makes it much more rewarding! The post How To: Remove Aluminum Siding appeared first on The Craftsman Blog. from https://thecraftsmanblog.com/how-to-remove-aluminum-siding/
0 Comments
Leave a Reply. |